Technical guide · Data and bus cables · Selection

LiYCY and LiYY are the same flexible data cable with one difference: the letter C. That letter is a copper braid shield — and whether you need it depends entirely on where the cable runs and what shares its route. This is the short, practical version of the decision.

Read the code

Li = fine-stranded flexible conductors, Y = PVC core insulation, Y = PVC jacket, C = copper braid shield. LiYY is the unshielded base cable; LiYCY adds the overall braid. Both are stationary-to-moderate-flex data and control cables — machine wiring, measurement and signal runs — not drag chain cables (for moving signal duty, see the TRVVSP class).

Side by side

PointLiYYLiYCY
ShieldNoneTinned copper braid, overall
Noise behaviourPicks up whatever the route offersRejects capacitive interference from neighbouring power runs
Diameter / handlingSlimmer, softest bendSlightly larger and stiffer — plan gland and entry space
PriceBaselineA step up for the braid and its termination work
Typical homeInside one cabinet, short protected runsBetween cabinets, along machines, anywhere near drives

When LiYY is enough

  • Runs inside a single control cabinet or enclosure, over short distances.
  • Routes with no power cables, drives or contactors nearby.
  • Digital signals with healthy noise margins in a controlled electrical environment.

When the C is not optional

  • The route leaves the cabinet or runs alongside power and motor cables — above all VFD-fed ones.
  • Analog measurement: 4–20 mA loops, temperature and sensor signals, where coupled noise becomes measurement error.
  • Long runs across a machine or between machines, where the cable is an antenna for everything it passes.

Terminating the shield: bring the braid out over the full 360° on a shield clamp or EMC gland at the cabinet entry — not a pigtail. For high-frequency interference, bond at both ends; on legacy low-frequency analog loops, follow the instrument maker’s instruction where it calls for single-end bonding to avoid ground-loop currents.

Variants worth knowing

LiYCY (TP) twists the cores in pairs under the braid — the step up when signals are differential (RS-485-style runs, balanced measurement), because twisting cancels magnetic coupling that a braid alone does not. And a boundary worth stating plainly: LiYCY is not a fieldbus cable. PROFIBUS, PROFINET and other bus systems specify impedance-controlled constructions; use the dedicated bus types (our selector has a bus and network group) rather than a look-alike data cable.

Frequently asked questions

Can LiYCY be used for an encoder?
For a fixed, protected run it is often used for signal wiring, but encoder feedback on a moving axis belongs in a drag-chain-rated pair construction (TRVVSP / servo feedback types). Match the cable’s flex class to the duty first, then the shielding.
Is shielded always better?
An unterminated shield protects nothing, and the braid adds cost, diameter and a termination step. Inside one cabinet on short runs, LiYY is the correct, economical specification. Outside that comfort zone, LiYCY earns its price.
What sizes exist?
Our standard table lists 471 LiYCY constructions — core counts from 2 upward, sizes in the 0.14–1.5 mm² data range — each with its outside diameter in the selector, so cabinet entries and glands can be planned before ordering.
LiYCY for RS-485?
Prefer the twisted-pair variant, LiYCY (TP), and respect the network’s length and termination rules. For a specified bus system, use its dedicated bus cable instead.

Not sure whether your route needs the shield?

Describe the run — length, what it carries, what it runs next to — and we will specify LiYY, LiYCY or the pair variant, and quote from the standard table.

LiYCY shielded data cables Request a quote